Greatneck 80122 Kullanıcı El Kitabı - Sayfa 12

Elektrikli Tornavida Greatneck 80122 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Greatneck 80122 17 sayfaları. 4.8 v cordless pivoting screwdriver

Sayfayı Yazdır

CHARGING THE BATTERY

Place the cordless screwdriver near a

120 V, 60 Hz electrical outlet.

Insert the battery charger plug (1) into

the charger receptacle (2) in the

handle of the cordless screwdriver (3)

(Fig. 1).

Plug the battery charger (4) into a

120 V 60 Hz wall receptacle.

NOTES:

a) The red indicator light (5) in the handle

will turn ON, indicating a positive

connection with the charger.

b) The red indicator light will remain ON

until the charger is disconnected.

c) A new battery or one that is completely

run down should be charged for 5 hours.

After normal use, a battery should be fully

charged in about 3 hours or more.

d) If the battery does not charge properly,

check to make sure the electrical outlet is

"live" and that the temperature range in the

work area is between 10–40°C (50–104°F).

Fig. 1

ASSEMBLY & OPERATION

INSTALLING SCREWDRIVER BITS

WARNING:

the cordless screwdriver near the switch

while changing screwdriver bits.

Accidentally touching the switch may

start the tool and possibly cause an

injury.

Select an appropriate screwdriver bit

that fits the head of the screw being

driven.

NOTES:

a) Use the largest size screwdriver bit

that will properly fit the screw head.

b) Make sure the screwdriver bit is in

good condition and is neither damaged

nor worn.

Insert the screwdriver bit (1) fully into

the screwdriver collet (2) (Fig. 2).

NOTES:

a) Make sure the screwdriver bit is fully

inserted into the collet.

b) If required, insert the magnetic hex

bit extension (3) into the collet first and

then insert the screwdriver bit fully into

the magnetic hex bit extension.

Never hold the body of

Fig. 2