ページを印刷するTHE SLOW MOTION KNOBS
To attach the slow motion knobs to your mount:
1. Locate the supplied hex key hidden inside the slot in the
Locate the supplied hex key hidden inside the slot in the
front of your mount.
2. Place the slow motion control knob over the D-shaped
Place the slow motion control knob over the D-shaped
gear shaft and push inward to make sure it is fully seated.
gear shaft and push inward to make sure it is fully seated.
3. Use the hex key to tighten the setscrews onto the gear
Use the hex key to tighten the setscrews onto the gear
shaft.
4. Return the hex key to its storage position in the front of
Return the hex key to its storage position in the front of
the mount.
THE TELESCOPE TUBE
To attach the telescope tube to your tripod and mount:
1. Locate the dovetail bar mounted on the side of the
telescope tube.
2. Holding the telescope tube next to the mount, slide the
dovetail bar into the clamp at the top of the mount.
3. Tighten the hand knob on the bottom of the clamp to
secure the telescope in place.
NOTE:
The 102 mm refractor is shown, but the 114 mm and 130 mm Newtonian telescopes
attach to the mount in the same way.
THE STAR DIAGONAL
The star diagonal attaches to the back of a refracting
telescope and contains a small prism that refl ects light
at a 90° angle, providing a more comfortable viewing
position.
Because a star diagonal gives you a 100%
correctly oriented image, you can easily use the telescope
for daytime terrestrial observing.
To insert the diagonal:
1. Remove the caps from both sides of the diagonal.
2. Loosen the setscrews on the back of the focuser and
pull out the small dust cap.
3. Insert the smaller tube on the diagonal into the back of
the focuser and secure it by tightening the setscrews.
You can rotate the diagonal to any position by loosening
the setscrews.
4
| ENGLISH
(FOR 102 MM REFRACTOR ONLY)