- ページ 8

アンプ Gainlab Audio BISHOPのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Gainlab Audio BISHOP 15 ページ。
Gainlab Audio BISHOP にも：クイック・スタート・マニュアル (10 ページ)

activated with the switch labeled HPF. The middle one is the off position. The

upper position of the switch turns on a high-pass ﬁlter with a frequency

of 120Hz with 6dB/oct order. The lower position of the switch turns on a

high-pass ﬁlter with a frequency of 60Hz with 6dB/oct order.

Another pillar of the ﬁlter section is the ﬁlter system

implementing the AIR function. In this case, we mean a

ﬁlter operating at the upper limit of the audible range and

at a higher frequency. This creates a very careful

shelving-like boost at the top of the audible frequency

range and complex saturation products at the high

frequency range, which makes it feel very airy and

pleasant. There are two available frequencies assigned to

the AIR function, which you can activate with the Dyn Air switch. The

middle position of the switch is the off state. By turning the switch up,

the 30KHz frequency can be reached. By turning the switch down, the 20KHz

frequency can be selected. If the compressor is switched off, the effect of

OUTPUT ATTENUATOR

The Bishop Channel Strip has an output attenuator to

make the most of the sound difference between the

ampliﬁcation modes and that the built-in optical

compressor can be used most widely. You can

attenuate a total of -12dB from the output level, using

the six-position rotary switch, of which the ﬁrst option

is the off state. Using the attenuator may reduce the signal/

noise ratio of the device.

SIDECHAIN LINK

There may be a recording situation where it is necessary to

the AIR function is static. But if the compressor and

the AIR function are switched on at the same time. The AIR

function is implemented dynamically in such a way that

the greater the gain reduction on the compressor,

the boost in the AIR band will be higher.

SC. LINK