- ページ 6

プリンター Gainscha GA-F3300のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Gainscha GA-F3300 14 ページ。 80mm thermal receipt printer

ページを印刷する

Thermal Receipt Printer

8. Functions of buttons and indicators

a. Print Self-testing page

* Printer status: Make sure the printer has thermal paper roll, then close the cover.

* Press the "Feed" button and hold it, then power on the printer. Release the hand holding

the "Feed" button after the error light is off (the buzzer beeps).

* The printer is automatically restored to normal mode after self-testing page printing

b. Buzzer switch

* Printer status: There is no paper roll in the printer, then close the printer cover.

* Press the "Feed" button and hold it, then power on the printer. Release the hand holding

the "Feed" button after the error light is off (the buzzer beeps).

* Put the paper roll back into the printer, then press the button and a notice will be printed.

c. Setting HEX mode

* Printer status: Make sure the printer has thermal paper roll, then close the cover.

* Press the "Feed" button before power on the printer. Release the hand holding the "Feed" button

after the three LED lights blink for three times.

* Press the "Feed" button within five seconds to enter HEX mode

* Long press the "Feed" button to cancel HEX mode.

d. Factory reset

* Printer status: Make sure the printer has thermal paper roll, then close the cover.

* Press the "Feed" button and hold it, then power on the printer. Release the hand after the three

LED lights blink for five times, and press the "Feed" button within five seconds.

* The factory settings are restored after the buzzer beeps three times, the printer will restart

Automatically.

e. Setting IAP mode

* Printer status: Make sure the printer has thermal paper roll, then close the cover.

* Press the "Feed" button and hold it, then power on the printer. Release the hand after the three

LED lights blink for five times, entering IAP mode.

* Restart the printer to cancel IAP mode.

f. Mode switch

* Printer status: Make sure the printer has thermal paper roll, then close the cover.

* Press the "Feed" button and hold it, then power on the printer. Release the hand after the buzzer

beeped three times, and then press the "Feed" button again.

* If continuous paper removal is in label mode, and single paper removal is in receipt mode.

9. Driver Setup

There are two ways to install the Driver for thermal receipt printer, one is to install the Driver

directly under WINDOWS, the other is to use the port directly.

* Install the Driver under WINDOWS

Add printer in WINDOWS, and specify the Driver file in the Driver disk to WINDOWS, only need

to call the Driver in the program and start printing. In this way, it is actually printed by the WINDOWS

printer program to convert characters into graphic dot matrix.

* Port drive directly

In this way, there is no need to use the Driver, only need to output the character directly to the

port, and by the printer's internal font library to realize the conversion of the character printing, using

the port direct drive mode, so that the printing control is more convenient.

In this way, you need to use the print command set to control the printing of the printer. The

80mm thermal receipt printer has integrated the ESC/POS command set.