コントローラー Dynamatic 4000のPDF インストラクションシートをオンラインで閲覧またはダウンロードできます。Dynamatic 4000 14 ページ。 With dancer position
Dynamatic 4000 にも：インストラクションシート (15 ページ), インストラクションシート (13 ページ), インストラクションシート (14 ページ), インストラクションシート (13 ページ)

ページを印刷する

Instruction Sheet

IS-539-15

revised 2019

15-533-1015 Panel Mount 4000 (4.3 A Controller)

15-551-1015 Standard Enclosure 4000 (4.3 A Controller)

15-539-0015 Panel Mount 4050 (8 A Controller)

15-553-0015 Standard Enclosure 4050 (8 A Controller)

Model 4000 and 4050 with Torque Limit and Jog at Run Speed

Introduction

These instructions relate specifically to

the model 4000 and 4050 controllers

assembled for Speed Control with

Torque Limit and Jog at Run Speed

modification.

Connection

schematic

diagram,

programming, plug wiring connection,

adjustment

procedure

recommended spare parts list for these

specific assemblies are contained in

this Instruction Sheet. Any differences

between these two controllers are

clearly noted. Use Instruction Manual

IM-130006-83XX with this Instruction

Sheet

for

complete

operation

and

instructions.

Caution: Above ground electrical

potentials scan be hazardous. Always

disconnect electrical power before

working on the controller.

*Heat sink assembly, HS1, and its

wiring are only supplied on 4050

controls. The parts are mounted on the

15-530-5 main 4000 boards.

diagram,

switch

and

installation,

maintenance

Drive Source International/Dynamatic

7900 Durand Ave Bldg 3 Sturtevant, WI 53177

[email protected]

800-548-2169 •