Dynamatic 4000 지침서
{카테고리_이름} Dynamatic 4000에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamatic 4000 14 페이지. With dancer position
Dynamatic 4000에 대해서도 마찬가지입니다: 지침서 (15 페이지), 지침서 (13 페이지), 지침서 (14 페이지), 지침서 (13 페이지)
페이지 인쇄
Instruction Sheet
IS-539-15
revised 2019
15-533-1015 Panel Mount 4000 (4.3 A Controller)
15-551-1015 Standard Enclosure 4000 (4.3 A Controller)
15-539-0015 Panel Mount 4050 (8 A Controller)
15-553-0015 Standard Enclosure 4050 (8 A Controller)
Model 4000 and 4050 with Torque Limit and Jog at Run Speed
Introduction
These instructions relate specifically to
the model 4000 and 4050 controllers
assembled for Speed Control with
Torque Limit and Jog at Run Speed
modification.
Connection
schematic
diagram,
programming, plug wiring connection,
adjustment
procedure
recommended spare parts list for these
specific assemblies are contained in
this Instruction Sheet. Any differences
between these two controllers are
clearly noted. Use Instruction Manual
IM-130006-83XX with this Instruction
Sheet
for
complete
operation
and
instructions.
Caution: Above ground electrical
potentials scan be hazardous. Always
disconnect electrical power before
working on the controller.
*Heat sink assembly, HS1, and its
wiring are only supplied on 4050
controls. The parts are mounted on the
15-530-5 main 4000 boards.
1
diagram,
switch
and
installation,
maintenance
Drive Source International/Dynamatic
7900 Durand Ave Bldg 3 Sturtevant, WI 53177
800-548-2169 •
www.Dynamatic.com