- ページ 5
防虫機器 Agrimate AF 4000NKのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Agrimate AF 4000NK 16 ページ。 Vehicle mount type
ページを印刷する
7. Leaking air from the
nipple.
8. Insufficient gasoline
or chemical/foreign
materials in the fuel
tank.
9. Carbon build up in the
thermal pipe.
B. When air leaks and makes a puck or when sound and the machine won't start.
Possible damage to the thermal pipe. Check to see what the damage is by using a flashlight.
To correct this problem replace the thermal pipe.
C. Chemical spraying won't work after the machine is started.
Cause
How to Check
Normally air enters the machine in only one direction, without any leaks. It is
1. Defective
defective if the side of the packing is torn or swollen. You should then replace
rubber liner in
the packing in the chemical check valve.
the chemical
To check the liner, put your tongue in the middle of it and when you blow, air
check valve
should move freely through the liner. If you try to suck air through the liner
using the same method as above no air should move through the liner.
If you separate the chemical spray pipe from
2. Blockage of the
the chemical nozzle and the chemicals do
chemical spray
not came out of the chemical tank then the
pipe
chemical spray pipe could be blocked.
If you separate the chemical spray pipe from
3. Blockage of the
the chemical nozzle and then chemicals do
chemical nozzle
not come out of the chemical tank then the
chemical nozzle could be blocked.
If you separate the chemical spray pipe from
4. Blockage of the
the chemical valve and then the chemicals do
chemical valve.
not come out of the chemical tank then the
chemical valve could be blocked.
5. Chemical cap
• The cap is defective when the user must hold
refuses to
close tightly
• Rubber packing is swollen.
To check use soap and water
to find where the air is leaking
from then replace the nipple
from which the air is leaking.
Check out fuel tank
Check to see if this is the
problems by using a flashlight.
If this is the problem then clean
the thermal pipe completely
with the cleaning rod.
the cap with his/her hand to start the machine.
Replace the nipple
• Clean the fuel tank
completely
• Change the gasoline
Check the spark plug and if
there is a carbon build-up
remove it with a screwdriver.
Solution
Using an air compressor,
blow the obstruction out of
the pipe.
• Replace chemical nozzle.
• Clean chemical nozzle
• Replace chemical valve.
• Clean the chemical valve
• Replace packing
• Make sure the cap is
5
with a thin metal wire.
by using air compressor
to force air through the
blockage.
closed completely.