- ページ 13

エンジン AutomationDirect SureServo2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。AutomationDirect SureServo2 18 ページ。 110/220 vac drives
AutomationDirect SureServo2 にも：クイック・スタート・マニュアル (2 ページ), クイック・スタート・マニュアル (4 ページ)

Connect to one external

regenerative resistor

Connect to external regenerative

resistors (serial connection)

Connect to external regenerative

resistors (parallel connection )

1 kW, 10Ω

• Normally, if the capacity of the regenerative resistor (the average value) is within the rated

capacity, the temperature of the resistor can increase to 120°C or even higher (under the

condition that the regenerative energy continues to be absorbed)� For safety reasons, please

use forced air cooling in order to reduce the temperature of the regenerative resistor�

Alternatively, you can use regenerative resistors that are equipped with thermal switches�

• When installing an external regenerative resistor, connect the external resistor to P3 and C

contacts� The P3 and D contacts are left open� It is recommended that you choose external

regenerative resistors of the resistance values specified above� For easy calculation of the

regenerative resistor capacity, there are two ways provided to calculate the capacity according

to the selected motor�

Rotary Motor:

Calculation of the regenerative power when there is no external torque, rotor inertia only

SureServo2 User Manual – 1st Edition – 05/20/2021

Settings:

P1.052 = 10 (Ω)

P1�053 = 1000 (W)

1 kW, 10Ω

Settings:

P1.052 = 20 (Ω)

1 kW, 10Ω

P1�053 = 2000 (W)

1 kW, 10Ω

Settings:

P1.052 = 5 (Ω)

P1�053 = 2000 (W)

1 kW, 10Ω

Chapter 2: Installation

Page 2–13