- ページ 5

デジタルカメラ Celestron StarSense AutoAlignのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Celestron StarSense AutoAlign 15 ページ。

ASSEMBLY

ATTACHING THE STARSENSE CAMERA TO

YOUR TELESCOPE

1. Remove the fi nderscope and bracket from your

telescope tube .

Note: Some optical tubes, like the NexStar SE, may have

a small plastic rail which secures the Star Pointer .

Remove this rail with a Phillips head screwdriver .

Remove StarPointer

2. Using the Optical Tube Compatibility Chart on

page 7, identify whether your telescope accepts

the small or large camera base .

Large Base

Using a Phillips head

screwdriver, install the

Small Base

appropriate base on your telescope .

Installing base with Phillips screwdriver

3. Slide the StarSense camera onto the camera

base and secure it with the thumbscrew(s) . The

camera slides on the large base front to back,

and slides on the small base back to front .

Installing large base (front to back)

Installing small base (back to front)

4. Plug the included auxiliary cable into the back

2. Remove the lens shroud by unthreading it .

of the StarSense Camera on one end, and your

mount's auxiliary port on the other end .

3. Slide the bracket off the front of the camera . Be

careful not to lose the two orange rings .

Note: If your telescope does not have an auxiliary port,

the Auxiliary Port Splitter, (item #93919 available

from Celestron), is required . First, plug the splitter

into the auxiliary port . Then, plug the hand control

into one port and the cable into the other .

CHANGING BRACKETS

To change from the pre-installed Large Camera

Bracket to the Small Camera Bracket:

1. Slightly loosen the socket head screw using the

4. Slide the new bracket onto the camera and screw

included 4mm Allen wrench . Do not remove the

the lens shroud back on . One orange ring should

screw entirely .

be in front of and behind the bracket as shown .