Celestron StarSense AutoAlign Посібник - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник для Цифрова камера Celestron StarSense AutoAlign. Celestron StarSense AutoAlign 15 сторінок.

ASSEMBLY

ATTACHING THE STARSENSE CAMERA TO

YOUR TELESCOPE

1. Remove the fi nderscope and bracket from your

telescope tube .

Note: Some optical tubes, like the NexStar SE, may have

a small plastic rail which secures the Star Pointer .

Remove this rail with a Phillips head screwdriver .

Remove StarPointer

2. Using the Optical Tube Compatibility Chart on

page 7, identify whether your telescope accepts

the small or large camera base .

Large Base

Using a Phillips head

screwdriver, install the

Small Base

appropriate base on your telescope .

Installing base with Phillips screwdriver

3. Slide the StarSense camera onto the camera

base and secure it with the thumbscrew(s) . The

camera slides on the large base front to back,

and slides on the small base back to front .

Installing large base (front to back)

Installing small base (back to front)

4. Plug the included auxiliary cable into the back

2. Remove the lens shroud by unthreading it .

of the StarSense Camera on one end, and your

mount's auxiliary port on the other end .

3. Slide the bracket off the front of the camera . Be

careful not to lose the two orange rings .

Note: If your telescope does not have an auxiliary port,

the Auxiliary Port Splitter, (item #93919 available

from Celestron), is required . First, plug the splitter

into the auxiliary port . Then, plug the hand control

into one port and the cable into the other .

CHANGING BRACKETS

To change from the pre-installed Large Camera

Bracket to the Small Camera Bracket:

1. Slightly loosen the socket head screw using the

4. Slide the new bracket onto the camera and screw

included 4mm Allen wrench . Do not remove the

the lens shroud back on . One orange ring should

screw entirely .

be in front of and behind the bracket as shown .