- ページ 7

ヘッドフォン HiFiMAN HE-560のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。HiFiMAN HE-560 8 ページ。
HiFiMAN HE-560 にも：オーナーズマニュアル (12 ページ), オーナーズマニュアル (8 ページ), オーナーズマニュアル (8 ページ)

www.hifiman.com

Set-up and Operation

1. Please allow at least 150 hours of constant use for break-in of your

new headphone. This break-in period does not have to be at high

volume.

2. To connect your headphones to an amplifier, please use the

supplied cabling. The mini-coax plug with the red dot goes to the right

side marked with R. (Depending on the cable in use, the cable itself

can also show L and R on the plugs.) Push the connector straight onto

the socket and then use your fingers to tighten the washer. When

tightening, please make sure to move the washer only and not the

cable as such. A loose connection can lead to drop outs and distortion.

Repeat the process with the other mini-coax connector.

3. The supplied cable adapter with the large ¼" (6.35mm) jack is

connected with the typical headphone output of an amplifier or even

better with a headphone amplifier. Please be aware that many home

amplifiers will switch off the loudspeaker output when a headphone is

connected.

4. To clean your headphone, please use a soft, slightly damp cloth only.

Do not use any detergents and make sure not to let any fluid enter the

open sides of the headphone. The leather headband can be

maintained using standard leather care products. When your earpads

become worn and no longer offer a good connection to your skull,

you should replace them with new ones which can be supplied from

your dealer. Note: The internal drivers do not require maintenance.

Any attempt to remove or modify them will void your warranty.