- ページ 11

プール掃除機 8STREME 7310のPDF マニュアルをオンラインで閲覧またはダウンロードできます。8STREME 7310 16 ページ。 New square swivel
8STREME 7310 にも：マニュアル (3 ページ), マニュアル (18 ページ)

ページを印刷する

1. Troubleshooting

The robot moves in one direction

The robot does not move and the filtration pump

does not work either. The robot doesn't work any

longer.

The pump runs but the robot does not move. The

robot turns on but stays on the spot.

Robot does not climb walls

- An object blocks the rollers, the wheels of the robot

or interfering with the movement of the robot.

-The robot is not connected to a power source. -

Power off

- No / not enough power is transmitted to the robot

- An object blocks the rollers, the belts, the wheels

of the robot or the path.

- Possibility of motor problem

- The robot is too heavy

- The flow is not enough

- The walls are too slippery

- The handle of the robot is poorly directed

- Check that there are no foreign objects in the

impeller located above the motor.

- Check that there are no foreign object blocking the

hydraulic circuit or the brushes and belts under the

robot and sides.

- Check that the power source is active by plugging

another device into the power outlet.

- Check that the power supply is turned on.

- Check all connections of the robot to the power

source.

- Unplug the power and take out the robot in the

water. Open the cover of the basket and remove the

basket.

- Check that there are no foreign objects in the

impeller located above the motor.

- Check that there are no foreign object blocking the

hydraulic circuit or the brushes and belts under the

robot and sides.

- Contact the After-sales Service

- Check that the collection of debris basket isn't full

- Check and clean if need the impeller of the pump

or the grid at the top of the impeller (propeller on

top of the robot toward the handle)

- Presence of algae on the walls or fatty deposits.

Remove algae using the chemical treatment of

water and manual brush to remove these fatty

deposits.

- Check that the handle of the robot is directed to

the rear. The cable should be above the handle.

PROBLEM

CAUS E(S)

SOLUTION(S)

The robot goes round in circles

- A belt is damaged

- one of the 4 side wheels is damaged or unscrewed

- Check the condition of the drive belts.

If necessary, replace the faulty belt.

- Check the wheels bolted to the ends of the rollers.

These wheels fit on the roll and then screw.

Page 11