8STREME 7310 Manual - Page 11

Browse online or download pdf Manual for Swimming Pool Vacuum 8STREME 7310. 8STREME 7310 16 pages. New square swivel
Also for 8STREME 7310: Manual (3 pages), Manual (18 pages)

Print Page
8STREME 7310 Manual
EN
The robot moves in one direction
The robot does not move and the filtration pump
does not work either. The robot doesn't work any
longer.
The pump runs but the robot does not move. The
robot turns on but stays on the spot.
Robot does not climb walls
- An object blocks the rollers, the wheels of the robot
or interfering with the movement of the robot.
-The robot is not connected to a power source. -
Power off
- No / not enough power is transmitted to the robot
- An object blocks the rollers, the belts, the wheels
of the robot or the path.
- Possibility of motor problem
- The robot is too heavy
- The flow is not enough
- The walls are too slippery
- The handle of the robot is poorly directed
- Check that there are no foreign objects in the
impeller located above the motor.
- Check that there are no foreign object blocking the
hydraulic circuit or the brushes and belts under the
robot and sides.
- Check that the power source is active by plugging
another device into the power outlet.
- Check that the power supply is turned on.
- Check all connections of the robot to the power
source.
- Unplug the power and take out the robot in the
water. Open the cover of the basket and remove the
basket.
- Check that there are no foreign objects in the
impeller located above the motor.
- Check that there are no foreign object blocking the
hydraulic circuit or the brushes and belts under the
robot and sides.
- Contact the After-sales Service
- Check that the collection of debris basket isn't full
- Check and clean if need the impeller of the pump
or the grid at the top of the impeller (propeller on
top of the robot toward the handle)
- Presence of algae on the walls or fatty deposits.
Remove algae using the chemical treatment of
water and manual brush to remove these fatty
deposits.
- Check that the handle of the robot is directed to
the rear. The cable should be above the handle.
PROBLEM
CAUS E(S)
SOLUTION(S)
The robot goes round in circles
- A belt is damaged
- one of the 4 side wheels is damaged or unscrewed
- Check the condition of the drive belts.
If necessary, replace the faulty belt.
- Check the wheels bolted to the ends of the rollers.
These wheels fit on the roll and then screw.
Page 11