- ページ 10

ソウ Galax Pro 766V-LのPDF 取扱説明書と安全上のご注意をオンラインで閲覧またはダウンロードできます。Galax Pro 766V-L 15 ページ。 Mini

ページを印刷する

a.Connect the small end of the

or (8)

to the

dust extraction port (5)

b.Connect the other end of the vacuum

to the end of a vacuum hose.

(8)

OPERATION

WARNUNG: Observe correct main voltage! The voltage of the power source

must agree with the voltage specified on the nameplate of the machine.

Switch On/Off

Before engage the

and run smoothly, the blade clamp bolt is well tightened.

To start the machine, press the

To stop the machine, release the

with the

lock-off button

release it.

Laser Function

WARNING: Do not stare directly at the laser beam, do not deliberately aim the

beam at personnel and ensure that it is not directed towards the eye of a person for

longer than 0.25s.

When you make the line of the cut on the work piece, the laser can help you get

better alignment.

a.Make sure line of the cut on the work piece.

b.Adjust the angle of cut as required

c.Plug in the machine and start the motor

d.When the blade is at its maximum speed (approximately 2 seconds), place the saw

on the work-piece.

e.Switch on the laser from the laser aperture using the

f.Align the beam with the mark on the work-piece and slowly push the saw forward

using both hands, keeping the red light beam on the mark.

Switch off the laser beam when completed the cut.

Cutting Methods

Parallel Cut Adjustment

Loosen the lock knob of

Slide the

edge guide (7)

vacuum adapt

on the tool.

ON/OFF switch

(15), check that the saw blade is properly fitted

ON/OFF switch (15)

(14), briefly press the

edge guide

through the slots in the shoe to the desired width.

Owner's Manual & Safety Instructions

adaptor

and keep it pressed.

ON/OFF switch (15)

laser switch

(12).

Mini Circular Saw

or when it is locked

(21).

Abb.7

and then