Galax Pro 766V-L Manual do proprietário e instruções de segurança - Página 10
Procurar online ou descarregar pdf Manual do proprietário e instruções de segurança para Serra Galax Pro 766V-L. Galax Pro 766V-L 15 páginas. Mini
Imprimir página
a.Connect the small end of the
or (8)
to the
dust extraction port (5)
b.Connect the other end of the vacuum
to the end of a vacuum hose.
(8)
OPERATION
WARNUNG: Observe correct main voltage! The voltage of the power source
must agree with the voltage specified on the nameplate of the machine.
Switch On/Off
Before engage the
and run smoothly, the blade clamp bolt is well tightened.
To start the machine, press the
To stop the machine, release the
with the
lock-off button
release it.
Laser Function
WARNING: Do not stare directly at the laser beam, do not deliberately aim the
beam at personnel and ensure that it is not directed towards the eye of a person for
longer than 0.25s.
When you make the line of the cut on the work piece, the laser can help you get
better alignment.
a.Make sure line of the cut on the work piece.
b.Adjust the angle of cut as required
c.Plug in the machine and start the motor
d.When the blade is at its maximum speed (approximately 2 seconds), place the saw
on the work-piece.
e.Switch on the laser from the laser aperture using the
f.Align the beam with the mark on the work-piece and slowly push the saw forward
using both hands, keeping the red light beam on the mark.
Switch off the laser beam when completed the cut.
Cutting Methods
Parallel Cut Adjustment
Loosen the lock knob of
a.
Slide the
edge guide (7)
b.
vacuum adapt
on the tool.
ON/OFF switch
(15), check that the saw blade is properly fitted
ON/OFF switch (15)
(14), briefly press the
edge guide
through the slots in the shoe to the desired width.
Owner's Manual & Safety Instructions
adaptor
and keep it pressed.
ON/OFF switch (15)
ON/OFF switch (15)
laser switch
(12).
Mini Circular Saw
or when it is locked
(21).
Abb.7
and then