- ページ 8

ティラー Agriweld 3M MINDISCのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Agriweld 3M MINDISC 20 ページ。

Only personnel with the appropriate experience should perform these
It is only permitted to replace the points on solid ground for e.g.
Cement/tarmac, to avoid the risk of sinking and potential injuries whilst
performing the changes. The implement must be raised on the tractor
linkage and the tractor engine turned off. Remember to use the parking
brake and/or wheel chocks to ensure that the tractor is held stable. It is
important to support the implements weight with stands/chocks strong
enough to support the full weight of the implement in the event of a
failure of the tractor hydraulics. Ensure that no one can start the tractor
and its hydraulic system accidentally by locking the cab door. It is
prohibited to work under a suspended load.
Once you are confident that you have met the safety standards required
Unbolt each worn point in turn to free it from the leg by removing the
M12 nylock nut and the M12 x 50mm long bolt. The point will be free to
remove. A new point can then be replaced into the same position using
the same M12 nylock nut and M12 x 50mm long bolt. Ensure the fixings
For CAST points (provided as standard) ensure that the fixings are NOT
over tightened to prevent potential damage. The point casting may crack
When you have finished replacing all required points, remove the
supporting chocks/stands and lower the machine as in the Think Safety
Section above until it is safe to move off.
REPLACING THE POINTS
changes.
you can proceed;
are tight.
if overtightened.
AW GLS point
M12
Nylock Nut
8
M12 x 50