Agriweld 3M MINDISC Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Tiller Agriweld 3M MINDISC. Agriweld 3M MINDISC 20 stron.

Only personnel with the appropriate experience should perform these

It is only permitted to replace the points on solid ground for e.g.

Cement/tarmac, to avoid the risk of sinking and potential injuries whilst

performing the changes. The implement must be raised on the tractor

linkage and the tractor engine turned off. Remember to use the parking

brake and/or wheel chocks to ensure that the tractor is held stable. It is

important to support the implements weight with stands/chocks strong

enough to support the full weight of the implement in the event of a

failure of the tractor hydraulics. Ensure that no one can start the tractor

and its hydraulic system accidentally by locking the cab door. It is

prohibited to work under a suspended load.

Once you are confident that you have met the safety standards required

Unbolt each worn point in turn to free it from the leg by removing the

M12 nylock nut and the M12 x 50mm long bolt. The point will be free to

remove. A new point can then be replaced into the same position using

the same M12 nylock nut and M12 x 50mm long bolt. Ensure the fixings

For CAST points (provided as standard) ensure that the fixings are NOT

over tightened to prevent potential damage. The point casting may crack

When you have finished replacing all required points, remove the

supporting chocks/stands and lower the machine as in the Think Safety

Section above until it is safe to move off.

REPLACING THE POINTS

changes.

you can proceed;

are tight.

if overtightened.

AW GLS point

M12

Nylock Nut

M12 x 50