- ページ 7

サブウーファー Hifonics Zeus ZRX200AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Hifonics Zeus ZRX200A 13 ページ。

IMPORTANT INFORMATIONS

ZRX200A

Subwoofer ................................................................................................................................................................................20 cm (8")

Output Power RMS ....................................................................................................................................................................150 Watts

Output Power Max. ....................................................................................................................................................................300 Watts

Lowpass Filter ........................................................................................................................................................................50 - 150 Hz

Phase Shift ...................................................................................................................................................................................0°/180°

Bass Boost .................................................................................................................................................................................0 - 12 dB

Subsonic Filter ................................................................................................................................................................................ 20 Hz

Frequency Response .................................................................................................................................................................30-150 Hz

Signal to Noise Ratio ......................................................................................................................................................................>90 dB

Input Sensitivity High Level ............................................................................................................................................................... 1,0 V

Input Sensitivity Low Level ............................................................................................................................................................ 300 mV

Operating Voltage ..................................................................................................................................+12 V (9 - 15 V), negative ground

Fuse Rating ....................................................................................................................................................................................... 25 A

Dimensions (W x H x L) ...............................................................................................................................................245 x 83 x 345 mm

All Specifications are subject to change.

CUSTOMER SERVICE

In general, the assembly and installation of the sound system should be made by a trained and technically skilled specialists. If you none-

theless choose the self-assembly and you have any problems, contact your specialist dealer or the Audio Design Service Department under

Tel. +49 7253 - 94 65 92 or by E-Mail to [email protected]

IMPORTANT NOTES PRIOR TO INSTALLATION

ATTENTION: Before you start with the installation, disconnect the ground connection from the vehicle's battery in order to prevent short

circuits. This guide is an installation aid for a proper installation of the sound system. Please read the following instructions:

• This device is only suited for a 12 volt system in a vehicle with negative ground.

• The radiated heat while operation requires sufficient air circulation at the place of installation.

• Ensure the accessibility of the fuse and the operating elements after installation.

• The reliability and performance of the device depends on the quality of installation.

• Please treat all parts of the sound system and the components of your vehicle with caution.

• Follow under all circumstance the regulations of the vehicle manufacturer and do not make any modifications

on the vehicle, which could interfere the driving safety.

INSTALLATION

Choose a suitable location for your device. The permanent temperature of the location should not be lower than 5°C and not higher than

50°C. Protect the device from moisture and humidity. Ensure that your device will not get loose during the drive and hurt someone in the

passenger cabin. Use therefor the included mounting brackets (4 x) and screws (8 x). Then use self-tapping screws (not included) from the

specialist trade, to fix the device in your vehicle.

Please observe not to damage any serial components of your vehicle (air bags, wires, gas tank etc.) during the installation of your device

by drilling or any other operations.

10 ~ 90%

5 ~ 50°C