- ページ 6

ラジオ Galaxy DX 88HLのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Galaxy DX 88HL 10 ページ。 Full channel am/fm/ssb mobile built in frequency counter am/fm 10w-ssb 25w with roger beep

ページを印刷する

5. MIC GAIN (inner dual concentric): Adjusts the microphone gain in

the transmit and PA modes. This controls the gain to the extent that full

talk power is available several inches away from the microphone.

6. RF GAIN CONTROL (outer dual concentric): Use to reduce the gain

of the RF amplifier under strong signal conditions.

7. BAND SELECTOR: This switch selects A, B, C, D, E, F, G or H band

of operation.

8. MODE (PA/FM/AM/USB/LSB): This switch is used to select PA, FM,

AM, LSB or USB mode of operation. Unless the station with which

communication is desired is equipped with SSB, the AM or FM mode is

normally used. The mode selector switch changes the mode of operation

of both transmitter and receiver simultaneously. Turn to "Receiving SSB

signals" for a further explanation of single sideband.

9. CLARIFIER: Allows variation of the receiver operating frequencies

above and below the assigned frequency. Although this control is

intended primarily to tune in SSB signals, it may be used to optimize

AM/FM signals as described in the Operating Procedure paragraphs.

Coarse operates both TX/RX but Fine only in RX.

10. CHANNEL SELECTOR: This switch selects any one of the forty

channels desired. The selected channel appears on the LED readout

directly above the Channel Selector knob.

11. METER: This meter indicates received signal strength, transmitter RF

output power and SWR level.

12. +10KHz FREQUENCY SHIFT SWITCH: When switch is pressed the

frequency is shifted 10KHz up. On following channels. A channel can

be used by setting this switch to +10KHz position.

Normal

13. ROGER BEEP SWITCH: When this switch is placed in the ROGER

BEEP position, your radio automatically transmits the audio sign at the

end of your transmission. The listener can note easily that your

transmission is over.

+10KHz

11A

15A

19A

- 9 -

14. POWER SWITCH: To select Hi (10 Watts) or Lo (3 Watts) power in

AM or FM transmission only.

15. OFF-NB/ANL SWITCH: In the NB/ANL position, the RF noise

blanker is activated and automatic noise limiter in the audio circuits is

also activated. The RF noise blanker is very effective for repetitive

impulse noise such as ignition interference.

16. COUNTER SWITCH-ON/OFF: Depressing this switch causes the

receiver and transmitter frequency to be displayed on the frequency

counter.

17. BAND SWITCH: This switch is used to select Hi or Lo Band selection.

18. FREQUENCY COUNTER: This frequency counter indicates of the

selected channel you wish to operate on.

19. RECEIVE/TRANSMIT INDICATOR: The receive/transmit LED

indicator is located next to the channel indicator. When in receive, the

LED will be green. When in transmit the LED will be red.

20. CHANNEL INDICATOR: Numbered LED indicates the selected

channel you wish to operate on.

- 10 -