- ページ 7

計測機器 DynaQuip WaterCop ClassicのPDF オーナーズマニュアル＆インストレーションマニュアルをオンラインで閲覧またはダウンロードできます。DynaQuip WaterCop Classic 20 ページ。

Sensor probes should be placed on the floor or in areas where water would tend to

accumulate rapidly in common leak or overflow situations .

Make sure that any water from a leak will drain toward the sensor probe, not away

from it. Avoid high traffic areas where the cord or sensor could be stepped on or

kicked and where children or pets may disturb it .

The sensor probe should be placed FLAT on the surface so water can be detected

as soon as it begins to accumulate. The sensor probe should be secured to the

surface . Do not use hook and loop fasteners to secure sensor probe as this will raise

the probe too high above the surface . To avoid damage to transmitters and to provide

for the strongest signal possible, the transmitter portion of the leak sensor should be

mounted in a convenient location (on the wall, in a cabinet, closet, etc . ) two to three

feet above the surface . (See Installation section for details on sensor installation.)

Leak Sensor Battery Life

High quality AA alkaline batteries from brands like Energizer® and/or Duracell®

are recommended for powering your WaterCop Classic sensors. It is

recommended that you replace the batteries in your WaterCop sensors at least

every 4 years. To ensure optimal performance of your WaterCop system, we

recommend an immediate change of the batteries in any sensor that has

detected a water leak. Sensors will sound an audible "chirp" sound when

batteries are low. After replacing batteries, re-test each unit in its regular

location. Periodic testing of sensors is required to monitor proper power and

function.

Operating the WaterCop® Classic System

The normal position of the valve is open to allow full flow throughout the plumbing

system . WaterCop® is a full port ball valve which does not restrict the flow capacity of

your plumbing system . The indicator lights on the face of the WaterCop® will show the

position of the valve .

If the valve is in the closed position (the red light will be lit), press OPEN and the valve

will move to the open position (green indicator will light) .

When water comes in direct contact with a leak sensor, an RF (radio frequency) signal

is transmitted to the WaterCop® and the valve closes, turning off the water source to

protect the building from additional damage .

The red indicator light will signal that the valve is now in the closed position, and

that you need to check all areas where you have placed a sensor to determine what

plumbing product caused the system to activate .