- ページ 6

計測機器 DynaQuip WaterCop ClassicのPDF オーナーズマニュアル＆インストレーションマニュアルをオンラインで閲覧またはダウンロードできます。DynaQuip WaterCop Classic 20 ページ。

Local electrical and plumbing codes should be consulted to ensure that the

installation is in complete compliance. (See Installation section for details.)

Notice: WaterCop® should be installed downstream of existing shut-off valves and

pressure reducers . Install 18" downstream from existing indoor water meters to allow

for future meter maintenance .

Placement of Wireless Sensors

Each WaterCop® Classic System can support an unlimited number of wireless

leak sensors . Additional sensors may be added at any time . A sensor consists of a

transmitter (a rectangular box) and a sensor probe (a small disc at the end of the wire,

with two short gold prongs protruding from one side) . Leak sensors should be placed

in locations where leaks are most likely to occur .

•

Washing Machines

•

Toilets

•

Ice Makers/Refrigerators

•

Dishwashers

•

Automatic Humidifiers

•

Kitchen Sinks

•

Bathroom Sinks

•

Water Heaters

•

Pipes that are prone to freezing (freeze

sensors are also available)

WARNING:

sprinkler systems.

The transmitter in the leak sensors and the

receiver in the WaterCop® communicate by

radio frequency . The smaller the distance

between them, the stronger the signal will be . The maximum transmission distance

is somewhat dependent upon the building layout and type of construction, but will

be in the 150'–200' range . The transmitter (attached to the sensor) must be kept dry .

It is NOT splash proof . Sensors should never be placed outdoors . The sensor probe

detects the water from a leak and is completely waterproof .

Do not use on fire