DynaQuip WaterCop Classic 사용 설명서 및 설치 설명서 - 페이지 6

{카테고리_이름} DynaQuip WaterCop Classic에 대한 사용 설명서 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaQuip WaterCop Classic 20 페이지.

Local electrical and plumbing codes should be consulted to ensure that the

installation is in complete compliance. (See Installation section for details.)

Notice: WaterCop® should be installed downstream of existing shut-off valves and

pressure reducers . Install 18" downstream from existing indoor water meters to allow

for future meter maintenance .

Placement of Wireless Sensors

Each WaterCop® Classic System can support an unlimited number of wireless

leak sensors . Additional sensors may be added at any time . A sensor consists of a

transmitter (a rectangular box) and a sensor probe (a small disc at the end of the wire,

with two short gold prongs protruding from one side) . Leak sensors should be placed

in locations where leaks are most likely to occur .

•

Washing Machines

•

Toilets

•

Ice Makers/Refrigerators

•

Dishwashers

•

Automatic Humidifiers

•

Kitchen Sinks

•

Bathroom Sinks

•

Water Heaters

•

Pipes that are prone to freezing (freeze

sensors are also available)

WARNING:

sprinkler systems.

The transmitter in the leak sensors and the

receiver in the WaterCop® communicate by

radio frequency . The smaller the distance

between them, the stronger the signal will be . The maximum transmission distance

is somewhat dependent upon the building layout and type of construction, but will

be in the 150'–200' range . The transmitter (attached to the sensor) must be kept dry .

It is NOT splash proof . Sensors should never be placed outdoors . The sensor probe

detects the water from a leak and is completely waterproof .

Do not use on fire