- ページ 5

制御システム DynaQuip WaterCop Pro WPK SeriesのPDF オーナーズマニュアルとインストレーションマニュアルをオンラインで閲覧またはダウンロードできます。DynaQuip WaterCop Pro WPK Series 16 ページ。

ページを印刷する

DynaQuip WaterCop Pro WPK Series オーナーズマニュアルとインストレーションマニュアル

into direct contact with a leak sensor's probe, an RF signal is transmitted to the Water Control

Panel and the valve closes, turning off the water source to protect the building from additional

water damage . The red indicator light will signal that the valve is now in the closed position . The

valve will remain closed until the unit is manually reset (through the manual override handle or

the OPEN button on the Water Control Panel) . After the plumbing problem is fixed, reset the

WaterCop® Pro by pressing the OPEN (green circle) on the face of the Water Control Panel .

NOTE: If major repairs are needed to correct the plumbing system, it is recommended that

the main shut-off valve upstream of the Actuator also be closed during the repairs . Close the

main water shut-off valve and unplug the Water Control Panel before making repairs on the

plumbing system .

In case of a power failure, use the manual shut-off valve to turn the water off in case of an

emergency . If enabled by the end user, the WaterCop® Pro Actuator will close the valve for Safe

Mode and will display "POWER RESTORED SAFE MODE CLOSED" on the Water Control Panel

once power is restored after any outage .

Enable/Disable "Safe Mode" Feature

TO ENABLE SAFE MODE:

1 . With the valve in the CLOSED position, press and hold down the MODE button . The display

will read:

2 . While holding down the MODE button, press the OPEN button, then release both

simultaneously . The Safe Mode feature will be enabled .

To verify that SAFE MODE is enabled, press & hold the MODE button . The display will read:

Release the MODE button . Then Press the OPEN button to return to WATERCOP NORMAL .

To Disable the Safe Mode feature, start with the valve in the closed position as noted above,

hold the MODE button & simply press CLOSE button instead and release . When Safe Mode

is disabled and power is restored, WaterCop will return to its last known position (Opened or

Closed) before power was lost .

WaterCop® Pro Specifications

Max . working pressure

Ambient temperature

Enclosure

Voltagex

Current

Valve

Valve seals

SAFE MODE = OFF

OPEN = ON CLOSE = OFF

SAFE MODE = ON

OPEN = ON CLOSE = OFF

125 psig

35° to 105° F

Polycarbonate NEMA 4

12 VDC plus 120 VAC adapter

0 . 8 5 Amps

Full-Port, Lead-Free, Brass, NPT

RTFE (Reinforced Teflon®)

Flow Data

Valve Size Cv = Gpm flow at

1 psi pressure drop

½" NPT

¾" NPT

1" NPT

1 ¼" NPT

For cold water applications