DynaQuip WaterCop Pro WPK Series Kullanım Kılavuzu ve Kurulum Kılavuzu - Sayfa 5
Kontrol Sistemleri DynaQuip WaterCop Pro WPK Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Kılavuzu indirin. DynaQuip WaterCop Pro WPK Series 16 sayfaları.
Sayfayı Yazdır
into direct contact with a leak sensor's probe, an RF signal is transmitted to the Water Control
Panel and the valve closes, turning off the water source to protect the building from additional
water damage . The red indicator light will signal that the valve is now in the closed position . The
valve will remain closed until the unit is manually reset (through the manual override handle or
the OPEN button on the Water Control Panel) . After the plumbing problem is fixed, reset the
WaterCop® Pro by pressing the OPEN (green circle) on the face of the Water Control Panel .
NOTE: If major repairs are needed to correct the plumbing system, it is recommended that
the main shut-off valve upstream of the Actuator also be closed during the repairs . Close the
main water shut-off valve and unplug the Water Control Panel before making repairs on the
plumbing system .
In case of a power failure, use the manual shut-off valve to turn the water off in case of an
emergency . If enabled by the end user, the WaterCop® Pro Actuator will close the valve for Safe
Mode and will display "POWER RESTORED SAFE MODE CLOSED" on the Water Control Panel
once power is restored after any outage .
Enable/Disable "Safe Mode" Feature
TO ENABLE SAFE MODE:
1 . With the valve in the CLOSED position, press and hold down the MODE button . The display
will read:
2 . While holding down the MODE button, press the OPEN button, then release both
simultaneously . The Safe Mode feature will be enabled .
To verify that SAFE MODE is enabled, press & hold the MODE button . The display will read:
Release the MODE button . Then Press the OPEN button to return to WATERCOP NORMAL .
To Disable the Safe Mode feature, start with the valve in the closed position as noted above,
hold the MODE button & simply press CLOSE button instead and release . When Safe Mode
is disabled and power is restored, WaterCop will return to its last known position (Opened or
Closed) before power was lost .
WaterCop® Pro Specifications
Max . working pressure
Ambient temperature
Enclosure
Voltagex
Current
Valve
Valve seals
SAFE MODE = OFF
OPEN = ON CLOSE = OFF
SAFE MODE = ON
OPEN = ON CLOSE = OFF
125 psig
35° to 105° F
Polycarbonate NEMA 4
12 VDC plus 120 VAC adapter
0 . 8 5 Amps
Full-Port, Lead-Free, Brass, NPT
RTFE (Reinforced Teflon®)
Flow Data
Valve Size Cv = Gpm flow at
1 psi pressure drop
½" NPT
¾" NPT
1" NPT
1 ¼" NPT
For cold water applications
19
34
52
77
5