- ページ 8
I/Oシステム Autonics ADIO-PNのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Autonics ADIO-PN 10 ページ。 Remote i/o boxes (profinet)
Autonics ADIO-PN にも： 製品マニュアル (10 ページ)
ページを印刷する
Port Connections
03. Connect with the atIOLink
Do not use the PDCT port and the Ethernet port at the same time.
04. Connect the power supply to ADIO
Be sure not to exceed 9 A of the maximum supplying current to the sensor (US).
01. Connect the M12 connector to the PDCT port. See the connections below.
1
Not Connected (N.C.)
1
2
2
Data -
3
5
4
Not Connected (N.C.)
4
3
5
Data +
02. Connect the connector to the network device.
• Network device: PC/laptop that atIOLink software is installed
03. Put the waterproof cover on the unused port.
01. Turn off all power.
02. Connect the 7/8" connector to the power supply port. See the connections below.
4
5
5
4
3
3
2
1
1
2
PWR OUT
PWR IN
0 V
1, 2
0 V
Sensor and actuator supply
3
F.G.
Frame ground
4
+24 VDCᜡ
Sensor supply
5
+24 VDCᜡ
Actuator supply