Autonics ADIO-PN Ürün Kılavuzu - Sayfa 8

I/O Sistemleri Autonics ADIO-PN için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. Autonics ADIO-PN 10 sayfaları. Remote i/o boxes (profinet)
Ayrıca Autonics ADIO-PN için: Ürün Kılavuzu (10 sayfalar)

Sayfayı Yazdır
Autonics ADIO-PN Ürün Kılavuzu
Port Connections
03. Connect with the atIOLink
᜸ Do not use the PDCT port and the Ethernet port at the same time.
04. Connect the power supply to ADIO
᜸ Be sure not to exceed 9 A of the maximum supplying current to the sensor (US).
01. Connect the M12 connector to the PDCT port. See the connections below.
1
Not Connected (N.C.)
1
2
2
Data -
3
5
4
Not Connected (N.C.)
4
3
5
Data +
02. Connect the connector to the network device.
• Network device: PC/laptop that atIOLink software is installed
03. Put the waterproof cover on the unused port.
01. Turn off all power.
02. Connect the 7/8" connector to the power supply port. See the connections below.
4
5
5
4
3
3
2
1
1
2
PWR OUT
PWR IN
0 V
1, 2
0 V
Sensor and actuator supply
3
F.G.
Frame ground
4
+24 VDCᜡ
Sensor supply
5
+24 VDCᜡ
Actuator supply