ページを印刷する孚 IR.C LE
INNER TIE ROD TOOL (028-035mm)
1. FEATURES
• To remove fast and easily worn axial joint on tie rod ends and install new tie rods with a 27mm spanner
• Special inner head design auto-grips axial joint firmly by turning clockwise and anti-clockwise.
• Mainly for European and Japanese small cars (below 2000cc)
• Width of application auto adjustable from 028mm-035mm.
氹
2. PRECAUTIONS
[
3
• Always read completely the instruction manual before working.
沄
Z
• Never use the tool in the areas that it is not designed for.
.
• Always wear eye protection that meets OSHA and ANSI Z87.1 standards.
• Always wear hand gloves when working with the tool.
• Ensure the work area has adequate lighting.
• Keep children and unauthorized persons away from the work area.
• Keep work area clean and tidy and free from unrelated materials.
• DO NOT allow untrained persons to use the kit.
3. SPECIFICATION
Head application
Head OD
4. INSTRUCTIONS
REMOVAL
Step 1 Remove the cotter pin on tie rod end.
Step 2 Insert the tie rod through the hollow body of the tool (Fig. 1)
Step 3 Ensure the rolling bars grip the axial joint securely.
Step 4 Use a spanner or a 1/2"DR ratchet to turn-anti clockwise for removal (Fig. 2)
NOTE
DO NOT use an air/impact tool to operate this tool.
INSTALLATION
Step 1 Insert a new tie rod through the hollow body of the tool.
Step 2 Use a spanner or a 1/2" DR ratchet and turn clockwise for installation.
Step 3 Put a cotter pin on the tie rod end.
丨
®
Unit: mm
¢28 - ¢ 35
¢ 72
Fig. 1
www.9circleint.com
Hex
27mm or 1/2"DR
Fig. 2