- ページ 12
双方向ラジオ Dynascan PMR446のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dynascan PMR446 16 ページ。 Handheld transceiver
Dynascan PMR446 にも： 取扱説明書 (11 ページ), 取扱説明書 (10 ページ)
ページを印刷する
The transceiver will return to the appointed channel after transmitting if there is no
operation in 10 seconds.
Menu 18: CTCSS/DCS scan (QTSEEK)):
This function allows saved the detected CTCSS/DCS tones during scanning.
Settings: RX QT, TX QT, RX/TX QT.
Default: RX QT.
Notes:
- The scan will not be enabled if no signal is received.
- Press [UP] / [DOWN] key to change the scan direction.
- Press [PF1] key to switch CTCSS and DCS scanning and press [PF2] key to
switch the positive and negative DCS codes.
- The detected CTCSS or DCS code will be shown on the LCD during the scanning,
and press [MENU] key to save it if need.
- Program the save mode by software.
Menu 19: Side key [PF1] settings (PF1):
You can program the functions of this key by short or long press.
Programmable functions: MONI/LAMP/SCAN/BATT-V/OFF.
Default: Short press is SCAN function and long press is MONI function.
MONI: Turn on/off the monitor function.
LAMP: Turn on/off the backlight function.
SCAN: Turn on/off the scan function.
BATT-V: Check the current battery voltage.
OFF: Without function.
Menu 20: Side key [PF2] settings (PF2):
You can program the functions of this key by short or long press.
Programmable functions: MONI/LAMP/SCAN/BATT-V/OFF.
Default: Short press is SCAN function and long press is MONI function.
MONI: Turn on/off the monitor function.
LAMP: Turn on/off the backlight function.
SCAN: Turn on/off the scan function.
BATT-V: Check the current battery voltage.
OFF: Without function.
Menu 21: Channel mode (CH-MDF):
There are two operating modes, frequency mode (VFO) and channel mode (CH).
Settings: CH/CHFREQ/NAME/FREQ.
Default: CH.
CH: Displayed the channel number.
CHFREQ: Displayed the channel number and frequency.
NAME: Displayed the channel name.
FREQ: Displayed the frequency.
English - 12 -