Dynascan PMR446 사용 설명서 - 페이지 12
{카테고리_이름} Dynascan PMR446에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynascan PMR446 16 페이지. Handheld transceiver
Dynascan PMR446에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지), 사용 설명서 (10 페이지)
페이지 인쇄
The transceiver will return to the appointed channel after transmitting if there is no
operation in 10 seconds.
Menu 18: CTCSS/DCS scan (QTSEEK)):
This function allows saved the detected CTCSS/DCS tones during scanning.
Settings: RX QT, TX QT, RX/TX QT.
Default: RX QT.
Notes:
- The scan will not be enabled if no signal is received.
- Press [UP] / [DOWN] key to change the scan direction.
- Press [PF1] key to switch CTCSS and DCS scanning and press [PF2] key to
switch the positive and negative DCS codes.
- The detected CTCSS or DCS code will be shown on the LCD during the scanning,
and press [MENU] key to save it if need.
- Program the save mode by software.
Menu 19: Side key [PF1] settings (PF1):
You can program the functions of this key by short or long press.
Programmable functions: MONI/LAMP/SCAN/BATT-V/OFF.
Default: Short press is SCAN function and long press is MONI function.
MONI: Turn on/off the monitor function.
LAMP: Turn on/off the backlight function.
SCAN: Turn on/off the scan function.
BATT-V: Check the current battery voltage.
OFF: Without function.
Menu 20: Side key [PF2] settings (PF2):
You can program the functions of this key by short or long press.
Programmable functions: MONI/LAMP/SCAN/BATT-V/OFF.
Default: Short press is SCAN function and long press is MONI function.
MONI: Turn on/off the monitor function.
LAMP: Turn on/off the backlight function.
SCAN: Turn on/off the scan function.
BATT-V: Check the current battery voltage.
OFF: Without function.
Menu 21: Channel mode (CH-MDF):
There are two operating modes, frequency mode (VFO) and channel mode (CH).
Settings: CH/CHFREQ/NAME/FREQ.
Default: CH.
CH: Displayed the channel number.
CHFREQ: Displayed the channel number and frequency.
NAME: Displayed the channel name.
FREQ: Displayed the frequency.
English - 12 -