- ページ 4

計測機器 Autool BT60のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Autool BT60 12 ページ。 Battery capacity monitor

the side to firmly fix the nut. (It will automatically identify the

type of 12V or 24V battery voltage and is displayed by LED )

● After this product is properly connected, it will detect the

voltage of the battery and display the corresponding voltage

value through 5 LEDs.

● Peel off the double-sided tape on the back of the product

and stick it to the top of the battery.

● Start the engine and the LED will light up in accordance

with the corresponding voltage value.

● The working mode of this product is to detect the battery

voltage and display the corresponding voltage value by LED,

which is kept for 3s. If it detects low voltage, the buzzer will

beep three times and then enter sleep mode. After keeping it

for 8s, it will switch to working mode again and the cycle

repeats.(When a 12V battery is detected, the buzzer will beep

three times if the voltage is below 10.5V; when a 24V battery

is detected, the buzzer will beep three times if the voltage is

below 21V)

※Cautions

● This connector is of the anti-drop type, so there is some

resistance to insertion.

*Place the connector on the cable connector bolt and push

slowly and firmly.

● If the battery is installed with a connector cover, be careful

not to interfere with this connector cover when installing the

product.

● Do not install it on the liquid port plug (vent) of the battery,

as this may cause rupture.

● Install this product in a location where the liquid nozzle