- ページ 3

カーアラーム Autopage RF-503のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Autopage RF-503 16 ページ。 Remote transmitters
Autopage RF-503 にも：マニュアル (2 ページ)

NOTE: If domelight supervision has been installed, the vehicle's dome light(s) will illuminate

with the disarm signal. The domelight will remain on for 60 seconds, or turn off immediately

after switching on the ignition.

2. TEMPORARY ARM/DISARM CHIRP DELETE FROM REMOTE

(Vehicle horn, or siren)

Upon approaching the vehicle (whether armed or disarmed) push Button II on the remote

transmitter for a half (0.5) second, then very quickly push Button I on the transmitter to arm or

disarm in the usual manner. The ARM/DISARM chirp sound will be silenced only for this

particular arming or disarming cycle. The above-described sequence must be repeated each

time it is desired to cancel the ARM/DISARM chirp sound.

3. PANIC FUNCTION

The RF-503 remote control may be used as a remote control panic switch to trigger the horn or

siren in cases of emergency. To activate the PANIC FUNCTION press and hold the Button I

on the remote transmitter for a minimum of three (3) seconds. The vehicle horn or siren will

sound. To stop the PANIC FUNCTION press Button I on the transmitter one more time.

4. DELETING THE PREWARNING SENSOR CIRCUIT (Standard & Optional)

The RF-503 offers the dual stage SIS-5 shock sensor to prewarn a light impact on the vehicle

with a horn or siren chirps. Additionally, a separate prewarn input is provided to connect other

sensors to further enhance the prewarn feature.

To delete the prewarn sensor feature armed, press Button I again within five (5) seconds after

arming. The horn or siren will confirm deletion with a low volume chirp.

NOTE: Utilizing the prewarn delete feature will delete both the standard shock sensor pre-warn

circuit, as well as any optional sensors connected to the separate pre-warn input.

NOTE: Deleted sensor(s) will return to normal operation upon disarming the RF-503. The

prewarn deletion procedure must be followed each time the RF-503 is armed.

NOTE: The prewarning feature is set inactive by the factory, and must be activated at the time

of installation if this feature is desired.