Autopage RF-503 Manual de instruções - Página 3
Procurar online ou descarregar pdf Manual de instruções para Alarme para automóvel Autopage RF-503. Autopage RF-503 16 páginas. Remote transmitters
Também para Autopage RF-503: Manual (2 páginas)
Imprimir páginaNOTE: If domelight supervision has been installed, the vehicle's dome light(s) will illuminate
with the disarm signal. The domelight will remain on for 60 seconds, or turn off immediately
after switching on the ignition.
2. TEMPORARY ARM/DISARM CHIRP DELETE FROM REMOTE
(Vehicle horn, or siren)
Upon approaching the vehicle (whether armed or disarmed) push Button II on the remote
transmitter for a half (0.5) second, then very quickly push Button I on the transmitter to arm or
disarm in the usual manner. The ARM/DISARM chirp sound will be silenced only for this
particular arming or disarming cycle. The above-described sequence must be repeated each
time it is desired to cancel the ARM/DISARM chirp sound.
3. PANIC FUNCTION
The RF-503 remote control may be used as a remote control panic switch to trigger the horn or
siren in cases of emergency. To activate the PANIC FUNCTION press and hold the Button I
on the remote transmitter for a minimum of three (3) seconds. The vehicle horn or siren will
sound. To stop the PANIC FUNCTION press Button I on the transmitter one more time.
4. DELETING THE PREWARNING SENSOR CIRCUIT (Standard & Optional)
The RF-503 offers the dual stage SIS-5 shock sensor to prewarn a light impact on the vehicle
with a horn or siren chirps. Additionally, a separate prewarn input is provided to connect other
sensors to further enhance the prewarn feature.
To delete the prewarn sensor feature armed, press Button I again within five (5) seconds after
arming. The horn or siren will confirm deletion with a low volume chirp.
NOTE: Utilizing the prewarn delete feature will delete both the standard shock sensor pre-warn
circuit, as well as any optional sensors connected to the separate pre-warn input.
NOTE: Deleted sensor(s) will return to normal operation upon disarming the RF-503. The
prewarn deletion procedure must be followed each time the RF-503 is armed.
NOTE: The prewarning feature is set inactive by the factory, and must be activated at the time
of installation if this feature is desired.
3