Autopage RF-503 Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Alarme para automóvel Autopage RF-503. Autopage RF-503 16 páginas. Remote transmitters
Também para Autopage RF-503: Manual (2 páginas)

Imprimir página

5. CHANGING THE REMOTE

TRANSMITTER BATTERY

The RF-503 remote transmitter uses one

(1) 12 volt miniature battery, #EL12,

#VR22, or Radio Shack #23-144. It will

provide approximately one year of

operation before replacement is necessary.

To replace the battery, carefully remove the

case screw located at the end of the remote

transmitter where the key ring attaches to its

case. Use a small blade Phillips

screwdriver. Use caution so as

not to bend or otherwise damage the

battery contacts. After replacing the

battery, replace the case cover and

carefully tighten the screw. Do not over-

tighten the screw. Test the transmitter to be

sure it arms and disarms the alarm.

B. LED STATUS INDICATOR OPERATION

1. LED OFF = The RF-503 is disarmed.

2. LED CONSTANT ON = Indicates open trigger circuit. The alarm cannot be armed.

3. LED FAST FLASHING = Passive arming timer is counting down.

4. LED FLASHING = The RF-503 is armed.

5. LED FLASHING IN A 2 FLASH/HOLD SEQUENCE = Alarm breach.

NOTE: If the automatic rearm feature was chosen at the time of installation, a door must be opened

after disarming. If a door is not opened, the RF-503 will automatically rearm in 60 seconds, and the

LED will continue to flash. See section (F ) AUTOMATIC REARM for details.