- ページ 5
おもちゃ DynaStar Rockets LexxJetのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DynaStar Rockets LexxJet 10 ページ。
ページを印刷する18. Locate the two remaining 24mm diam-
eter tubes. Draw a single line down the length
of each tube. Measure and mark a line 0.75
inch (19mm) from one end of the tubes.
Cut out the Jet Exhaust tube cutting guide
from page 11. Wrap the guide around one of
the tubes and tape the ends together. Slide
the guide so the rounded edge is at the 0.75
inch (19mm) line and so that the line on the
cutting guide is positioned over the line drawn
down the length of the tube. Tape it down so it
can't move. Draw a line around the perimeter
of the tube along the curved edge of the cut-
ting guide. Remove the marking guide. Repeat
this process on the other tube.
19.Carefully cut along the curved pencil
line drawn on the tube in the previous step to
make the diagonal end-cut. Sand the edge on
a piece of sandpaper laid on a flat surface to
make the edge perfectly flat. Repeat for the
other tube.
20. Glue the diagonal cut tube from the
previous step onto the jet engine balsa stand-
off using wood glue. The tip of the diagonal
edge is aligned with the diagonal edge of the
standoff piece. Make sure the tube is straight
inside the forward nacelle tube. Repeat with
the other diagonal cut tube. Allow the glue to
dry.
21. Cut out the tube marking guide from
page 11. Wrap the guide around the big tube
and tape the ends together. Using a pencil,
make a tick-mark on the tube at the end of
each arrow point on the guide. Remove the
guide. Using an angle-channel as a guide,
draw straight lines along the entire length of
the tube at each tick mark.
0.75" (19mm)
Perform two times
Perform two times
Front View
Page
5