DynaStar Rockets LexxJet Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка DynaStar Rockets LexxJet. DynaStar Rockets LexxJet 10 сторінок.

18. Locate the two remaining 24mm diam-

eter tubes. Draw a single line down the length

of each tube. Measure and mark a line 0.75

inch (19mm) from one end of the tubes.

Cut out the Jet Exhaust tube cutting guide

from page 11. Wrap the guide around one of

the tubes and tape the ends together. Slide

the guide so the rounded edge is at the 0.75

inch (19mm) line and so that the line on the

cutting guide is positioned over the line drawn

down the length of the tube. Tape it down so it

can't move. Draw a line around the perimeter

of the tube along the curved edge of the cut-

ting guide. Remove the marking guide. Repeat

this process on the other tube.

19.Carefully cut along the curved pencil

line drawn on the tube in the previous step to

make the diagonal end-cut. Sand the edge on

a piece of sandpaper laid on a ﬂat surface to

make the edge perfectly ﬂat. Repeat for the

other tube.

20. Glue the diagonal cut tube from the

previous step onto the jet engine balsa stand-

off using wood glue. The tip of the diagonal

edge is aligned with the diagonal edge of the

standoff piece. Make sure the tube is straight

inside the forward nacelle tube. Repeat with

the other diagonal cut tube. Allow the glue to

dry.

21. Cut out the tube marking guide from

page 11. Wrap the guide around the big tube

and tape the ends together. Using a pencil,

make a tick-mark on the tube at the end of

each arrow point on the guide. Remove the

guide. Using an angle-channel as a guide,

draw straight lines along the entire length of

the tube at each tick mark.

0.75" (19mm)

Perform two times

Front View

Page