DynaStar Rockets LexxJet Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка DynaStar Rockets LexxJet. DynaStar Rockets LexxJet 10 сторінок.

13. USE ONLY WOOD GLUE FOR THIS

STEP! Glue the disk centering ring at the 1.0

inch (25.4mm) line on the engine tube. The

large green ring is glued up against the disk

ring. While the glue is still wet, pull the shock

cord tight up against the green ring. Apply a

bead of wood glue over the shock cord to hold

it down against the engine tube.

Allow the glue to completely dry. Once it is

inside the plastic boattail, it will never dry be-

cause air cannot circulate around the glue. So

it must be completely dry before continuing.

14. Glue the two winglets on the tips of the

two wings using wood glue. Make sure they

are perpendicular to the wing. Allow the glue

time to dry.

15. Cover work surface with a piece of

plastic to keep the parts from sticking to it.

Then glue the two wing halves together using

wood glue. The root edge joint should lay ﬂat

on the table, and the winglets will lift up the

tips to give the correct amount of dihedral. Al-

low the glue to completely dry, and then apply

glue ﬁllets to all the joints.

16. Glue the horizontal tail ﬁns onto the top

of the vertical tail using wood glue. Make sure

that it is not skewed. Allow the glue to com-

pletely dry, and then apply glue ﬁllets to all the

joints.

17. Draw a line down the length of each of

the two jet engine nacelles [the tubes that are

1.325 inch (33mm) diameter by 2.25 inches

(57 mm) long]. Glue the nacelle tubes to the

balsa stand-off pieces with wood glue. Use the

line on the tubes to make sure the tubes are

aligned straight along the tube.

Page

Perform two times

Joint rests on the table surface.

Rear view showing dihedral

Perform two times