- ページ 5

電気ヒーター Dynasty Fireplaces EF43DのPDF 取付説明書＆取扱説明書をオンラインで閲覧またはダウンロードできます。Dynasty Fireplaces EF43D 9 ページ。 Electric heater with remote control
Dynasty Fireplaces EF43D にも：ホームオーナー用設置説明書＆取扱説明書 (8 ページ)

ページを印刷する

OPERATING INSTRUCTION

Power

Make sure the Power Switch, located on the control panel, is in the OFF position. Plug the power

cord into a 110~120 Volt 15 Amp outlet. Make sure the outlet is in good condition and that the plug

is not loose. NEVER exceed the maximum amperage for the circuit. DO NOT plug other appliances

into the same circuit.

Temperature Limiting Control

This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe

temperature, the heater will automatically turn OFF. To reset:

Unplug the power cord from the outlet.

Turn the Power Switch on the CONTROL PANEL to OFF. Wait at least 5 minutes.

3. Inspect the fireplace to make sure no vents are blocked or clogged with dust or lint. If they

are, use a vacuum to clean the vent areas.

With the Power Switch in the OFF position, plug the power cord back into the outlet.

5. If it switches off again, UNPLUG THE HEATER RIGHT AWAY! Have the outlets, wiring,

and breaker box inspected by a professional. Make necessary repairs before using the

heater .

Heater Rating

Maximum heat output: 1500W (4600BTU); Maximum heating area: 400 square feet.

Operation

Read and understand this entire owner's manual, including all safety information,

before plugging in or using this product. Failure to do so could result in electric shock,

fire, serious injury, or death.

Heating Indicator Light

& Remote Receiver

Heating Indicator Light