- ページ 3

コントロールユニット Autoplugin Key-V3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Autoplugin Key-V3 8 ページ。

Description

The Autoplugin Key-V3 is an electronic module designed to add a remote control

function to the fuel-fired heater (parking heater, fuel operated heater, pre-heater),

factory installed in Volvo С30 (2006-2012), S40 (2004-2012), V50 (2004-2012) or

C70 (2006-2013). The device is plugged into the diagnostic socket placed on the

dashboard, and controls the heater via CAN-bus.

· Immediate start of the heater with Volvo car's key. Both a key with 5

buttons and a PCC key with 6 buttons can be used for the heater control

· Immediate stop of the heater with Volvo car's key

· Indication of the heater autonomous operation with direction indicators

flashing in rearview mirrors.

· Additional main battery protection from discharging by inspecting of

voltage level and time of heater autonomous operation

1. Autoplugin Key-V3 cartridge

2. User Manual brochure

The module needs that 2 timers and direct start / stop function for the heater

control are present in CIP. Therefore it may be necessary to load the special

software to the CIP at first by the means of Volvo dealer's equipment.

Autoplugin Key does not need professional installation. Find the diagnostic socket

at the left lower point of the dashboard. The socket is placed near to the handle for

bonnet opening. Take the module to your hand and gently push it into the socket.

LED starts flashing for approximately 10 seconds, waiting for information from

CAN-bus. Wait until the LED stops flashing before operation. Turn the ignition on

if the LED continues flashing after 10 seconds expired.