- ページ 5
コントロールユニット Autoplugin Key-V3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Autoplugin Key-V3 8 ページ。
ページを印刷するIf entered digit is not correct, press and release "Read/OK" button until the module
indicates an error. Enter the code once more in that case. Several codes can be
entered without exit of setup mode.
Turn the ignition off to exit from the Setup mode. New settings are saved in the
non-volatile memory of the module and stored there regardless of whether the
module is connected or not. Note: start the engine inside the Setup mode if you
want to exit without saving of new settings.
To reset the module to factory settings, enter the code 8.1.1. Both direction
indicators in the CIP should flash three times, confirming command execution.
Then the module exits Setup mode and restarts.
Settings
Settings
Group
Item
1.1. Limitation of
1.
Heater's
heater total
operation
operational time in
time
pre-heat mode
1.2. Limitation of
heater 1-cycle
operational time in
pre-heat mode
2.1. "Lock" and
2.
Heater
"Lamp" buttons
control with
functions for heater
remote
control
control key
2.2. Number of
sequential "Lamp"
button presses for
heater control
2.3. Number of
sequential "Lock"
button presses for
heater control
(when perimeter
lighting is on)
5
Possible Values
1.1.1 *Not adjusted
1.1.2 40 minutes
1.1.3 50 minutes
1.1.4 60 minutes
1.1.5 70 minutes
1.1.6 80 minutes
1.1.7 90 minutes
1.1.8 100 minutes
1.1.9 120 minutes
1.2.1 10 minutes
1.2.2 15 minutes
1.2.3 20 minutes
1.2.4 25 minutes
1.2.5 30 minutes
1.2.6 40 minutes
1.2.7 50 minutes
1.2.8 60 minutes
1.2.9 *Not adjusted
2.1.1 *"Lock" button for the heater start,
"Lamp" button for the heater stop
2.1.2 "Lamp" button for the heater start,
"Lock" button for the heater stop
2.2.1 Two presses
2.2.2 *Four presses
2.2.3 Six presses
2.2.4 Combination is disabled
2.3.1 One press
2.3.2 *Two presses
2.3.3 Three presses
2.3.4 Combination is disabled
Settings table (1)