- ページ 9

リフティングシステム Dynatech QUASARのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dynatech QUASAR 14 ページ。 Overspeed governor

INSTRUCTIONS: QUASAR Cod: DYN 48.1.07
Fecha: 04/12/2017 Revisión: 07

5 FIXING TO THE SLAB

The figure displays the governor's anchoring points to the slab: Measurements are given in millimetres.
X=12.5 mm Quasar (6/6,5 mm rope)
The figure above displays the floor plan view of the governor's motherboard.
The governor is anchored to the slab via the slotted holes on the board.
It also displays the rope and its location with reference to the motherboard.

6 UCM UNCONTROLLED MOVEMENT DEVICE

UCM WARNINGS
The anti-creep system requires the lift controller to be able to manage the functions that the anti-creep system uses,
such as the coil power, control sensor monitoring and manual rescue. If the controller is unable to manage these
functions, Dynatech offers the possibility of installing an electronic module, D-Box. For more information, see the
website.
If the D-Box is not used, please observe the following warnings and follow the recommendations below for proper
controller design.
Note. It is highly recommended that the controller designer contacts Dynatech before designing the circuit to
manage the anti-creep system, to clarify any doubts regarding connections and to be recommended a specific
solution for their installation
6
Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer
area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/