Dynatech QUASAR 사용 설명서 지침 - 페이지 9

{카테고리_이름} Dynatech QUASAR에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynatech QUASAR 14 페이지. Overspeed governor

INSTRUCTIONS: QUASAR Cod: DYN 48.1.07

Fecha: 04/12/2017 Revisión: 07

5 FIXING TO THE SLAB

The figure displays the governor's anchoring points to the slab: Measurements are given in millimetres.

X=12.5 mm Quasar (6/6,5 mm rope)

The figure above displays the floor plan view of the governor's motherboard.

The governor is anchored to the slab via the slotted holes on the board.

It also displays the rope and its location with reference to the motherboard.

UCM WARNINGS

The anti-creep system requires the lift controller to be able to manage the functions that the anti-creep system uses,

such as the coil power, control sensor monitoring and manual rescue. If the controller is unable to manage these

functions, Dynatech offers the possibility of installing an electronic module, D-Box. For more information, see the

website.

If the D-Box is not used, please observe the following warnings and follow the recommendations below for proper

controller design.

Note. It is highly recommended that the controller designer contacts Dynatech before designing the circuit to

manage the anti-creep system, to clarify any doubts regarding connections and to be recommended a specific

solution for their installation

Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer

area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/