- ページ 2

ソウ Dynatech BBMのPDF その他のメンテナンスと修理に関する説明をオンラインで閲覧またはダウンロードできます。Dynatech BBM 10 ページ。 Mini masonry saw

BBM & YBM INSTRUCTIONS [May 2004]

DISCONNECT ALL POWER TO THE SAW!

NEVER ATTEMPT ANY OF THE INSTRUCTIONS WITH POWER CONNECTED TO SAW!

Removing the Motor

1. Remove the two plastic plugs in the blade guard to expose

the two blade guard mounting screws located under the

blade guard.

2. Using a 17mm wrench, turn the blade shaft

screw clockwise and take the screw and

washer out of the end of the shaft. With the

blade shaft screw and washer removed, pull

both blade flanges outward and off the end of

the blade shaft.

3. Insert a Phillips head screw driver into the blade guard screw

access holes and remove the two screws holding the blade guard

on the cutting head casting.

4. From under the blade guard, remove the two screws

located at the bottom of the blade shaft housing

casting and pull the blade guard outward and off the

blade shaft casting housing.

5. Using a narrow tip slot screw driver remove the two white motor

wires in the terminal block.

6. Remove the air filter.

NEVER ATTEMPT ANY OF THE INSTRUCTIONS WITH POWER CONNECTED TO SAW!