Dynatech BBM Додаткові інструкції з технічного обслуговування та ремонту - Сторінка 2

Переглянути онлайн або завантажити pdf Додаткові інструкції з технічного обслуговування та ремонту для Пила. Dynatech BBM. Dynatech BBM 10 сторінок. Mini masonry saw

Друкувати сторінку
BBM & YBM INSTRUCTIONS [May 2004]
DISCONNECT ALL POWER TO THE SAW!
NEVER ATTEMPT ANY OF THE INSTRUCTIONS WITH POWER CONNECTED TO SAW!
Removing the Motor
1. Remove the two plastic plugs in the blade guard to expose
the two blade guard mounting screws located under the
blade guard.
2. Using a 17mm wrench, turn the blade shaft
screw clockwise and take the screw and
washer out of the end of the shaft. With the
blade shaft screw and washer removed, pull
both blade flanges outward and off the end of
the blade shaft.
3. Insert a Phillips head screw driver into the blade guard screw
access holes and remove the two screws holding the blade guard
on the cutting head casting.
4. From under the blade guard, remove the two screws
located at the bottom of the blade shaft housing
casting and pull the blade guard outward and off the
blade shaft casting housing.
5. Using a narrow tip slot screw driver remove the two white motor
wires in the terminal block.
6. Remove the air filter.
NEVER ATTEMPT ANY OF THE INSTRUCTIONS WITH POWER CONNECTED TO SAW!