- ページ 6

計測機器 Gallagher C500615のPDF インストレーション・ノートをオンラインで閲覧またはダウンロードできます。Gallagher C500615 8 ページ。 Smb monitoring kit

Connecting via Wi-Fi

Connecting via WPS

1. Enable WPS on the router.

2. Press and hold the WPS button on the Alula BAT-Connect until the Wi-Fi LED flashes.

3. Unplug the ethernet cable (if used). After approximately 1-2 minutes, the Wi-Fi LED will

turn on. Wi-Fi network credentials are now saved on the Alula BAT-Connect.

4. If the Wi-Fi LED does not turn on after 2 minutes, then WPS was not successful. Repeat

steps 1-3.

Connecting via AlulaConnect™ (if WPS is unavailable)

1. Wi-Fi credentials can be entered at alulaconnect.com. For the Wi-Fi credentials to be

pushed from AlulaConnect,the BAT-Connect must be online.

2. Go to Account > Account Devices > BAT-Connect > Communication > Primary Wi-Fi

Credentials (Enter information) > Save.

3. The Wi-Fi LED will turn on (this may take up to 2 minutes.) Wi-Fi network credentials

are now saved in BAT-Connect. Note: It should switch to Wi-Fi, regardless of the active

interface previously used (ethernet or cell).

4. If the Wi-Fi LED does not turn on after 2 minutes:

- Repeat step 2, verifying that the credentials entered are correct.

- Verify the BAT-Connect is online.

5. Ensure the UDP ports 1234 and 1235 are open on the customers' network.