Gallagher C500615 Notas de instalação - Página 6

Procurar online ou descarregar pdf Notas de instalação para Instrumentos de medição Gallagher C500615. Gallagher C500615 8 páginas. Smb monitoring kit

Imprimir página
Gallagher C500615 Notas de instalação
Connecting via Wi-Fi
Connecting via WPS
1. Enable WPS on the router.
2. Press and hold the WPS button on the Alula BAT-Connect until the Wi-Fi LED flashes.
3. Unplug the ethernet cable (if used). After approximately 1-2 minutes, the Wi-Fi LED will
turn on. Wi-Fi network credentials are now saved on the Alula BAT-Connect.
4. If the Wi-Fi LED does not turn on after 2 minutes, then WPS was not successful. Repeat
steps 1-3.
Connecting via AlulaConnect™ (if WPS is unavailable)
1. Wi-Fi credentials can be entered at alulaconnect.com. For the Wi-Fi credentials to be
pushed from AlulaConnect,the BAT-Connect must be online.
2. Go to Account > Account Devices > BAT-Connect > Communication > Primary Wi-Fi
Credentials (Enter information) > Save.
3. The Wi-Fi LED will turn on (this may take up to 2 minutes.) Wi-Fi network credentials
are now saved in BAT-Connect. Note: It should switch to Wi-Fi, regardless of the active
interface previously used (ethernet or cell).
4. If the Wi-Fi LED does not turn on after 2 minutes:
- Repeat step 2, verifying that the credentials entered are correct.
- Verify the BAT-Connect is online.
5. Ensure the UDP ports 1234 and 1235 are open on the customers' network.