- ページ 17

アクセサリー Emerson FB1100のPDF ターミネーション・ボード現場交換マニュアルをオンラインで閲覧またはダウンロードできます。Emerson FB1100 18 ページ。 Flow computer coin cell battery field
Emerson FB1100 にも：交換マニュアル (18 ページ), フィールド交換マニュアル (14 ページ), フィールド交換マニュアル (20 ページ), フィールド交換マニュアル (8 ページ), フィールド交換マニュアル (8 ページ), 交換マニュアル (8 ページ)

FB1100/FB1200 Flow Computer Termination Board Field Replacement Guide

12. If you have an internal battery, you can re-connect it now, and put the HMI module

back on. To replace the HMI module, line up the printed circuit board (PCB) with

the slot on the back of the replacement module and gently press the new HMI

module on. Tighten the four captive fastening screws with a torque of 6 in-lbs (0.7

N m).

13. You can now plug your new terminal blocks back into the termination board,

leaving TB1 last for when you want to restore power.

14. Carefully align the end cap threads with the threads of the enclosure and replace

the rear end cap. Screw the end cap clockwise (eight full turns) until it is tightly

sealed to the enclosure. Endcaps must have at least 8 full threads engaged upon

reassembly.

Note

If you need more leverage place a long screwdriver or other appropriate tool

across the two notches in the cover to act as a pry bar.

15. If applicable, tighten the retaining clamp onto the end cap using a 3mm

hexagonal wrench. When tightening, torque to 10 to 12 in-lbs (1.1 to 1.4 N m).

D301820X012

March 2018