Emerson FB1100 종단 보드 현장 교체 매뉴얼 - 페이지 17

{카테고리_이름} Emerson FB1100에 대한 종단 보드 현장 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Emerson FB1100 18 페이지. Flow computer coin cell battery field
Emerson FB1100에 대해서도 마찬가지입니다: 교체 매뉴얼 (18 페이지), 현장 교체 매뉴얼 (14 페이지), 현장 교체 매뉴얼 (20 페이지), 현장 교체 매뉴얼 (8 페이지), 현장 교체 매뉴얼 (8 페이지), 교체 매뉴얼 (8 페이지)

FB1100/FB1200 Flow Computer Termination Board Field Replacement Guide

12. If you have an internal battery, you can re-connect it now, and put the HMI module

back on. To replace the HMI module, line up the printed circuit board (PCB) with

the slot on the back of the replacement module and gently press the new HMI

module on. Tighten the four captive fastening screws with a torque of 6 in-lbs (0.7

N m).

13. You can now plug your new terminal blocks back into the termination board,

leaving TB1 last for when you want to restore power.

14. Carefully align the end cap threads with the threads of the enclosure and replace

the rear end cap. Screw the end cap clockwise (eight full turns) until it is tightly

sealed to the enclosure. Endcaps must have at least 8 full threads engaged upon

reassembly.

Note

If you need more leverage place a long screwdriver or other appropriate tool

across the two notches in the cover to act as a pry bar.

15. If applicable, tighten the retaining clamp onto the end cap using a 3mm

hexagonal wrench. When tightening, torque to 10 to 12 in-lbs (1.1 to 1.4 N m).

D301820X012

March 2018