- ページ 6
アンプ Gallien-Krueger 700RB-IIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gallien-Krueger 700RB-II 8 ページ。 Artist series
Gallien-Krueger 700RB-II にも： オーナーズマニュアル (16 ページ)
ページを印刷する
1
2 3
4
Front Panel Features
Balanced Direct Out: An electronically balanced low
1
impedance output that you can run to your P.A. system
via a mic cable.
Ground/Lift: Used
2
c o n n e c t i n g to equipment that is running on a
different ground system.
Pre/Post EQ Button: Sets the Direct Out signal before
3
or after the EQ.
Direct Out Level: Controls the output level of the
4
Direct Out.
Input: A standard ¼" input jack to plug in active
5
or passive basses using an instrument (shielded)
cable.
-14dB Pad & Clip LED: Reduces the input signal
6
from your bass. Press in if the Clip LED lights up
excessively
Tuning Mute Button: Mutes all output signals except
7
for the Tuner output. LED turns on when 'Tuning
Mute' is engaged.
Volume: Sets the pre-amp gain after the input stage.
8
4/5 String Bass: When engaged, this extends the low
9
frequency range.
Contour: Cuts the mid-range frequencies while
10
boosting lows & highs.
Presence: Adds edge and definition to higher
11
frequencies.
Treble: Active shelving type control which boosts
12
and cuts the high frequencies.
High Mid: Active band pass type control which boosts
13
and cuts at about 1kHz.
700RB-II & 1001RB-II
5
6
7
8
9
10
11
to
eliminate
hum
when
12
13
14
15
16
Low Mid: Active band pass type control which boosts
14
and cuts at about 250Hz.
Bass: Active shelving type control which boosts and cuts
15
the low frequencies.
Boost: A post EQ gain stage using GK's exclusive Valve
16
Effect technology, which adds 'growl' as it is turned up.
Tweeter: Master volume control for the 50 watt horn
17
amp. Output signal is 5kHz and above.
Tweeter Hi-Cut: Cuts frequencies above 10kHz,
18
which is useful for reducing hiss from the tweeter.
Woofer/Master: Master volume control for the
19
woofer (Main) amplifier. Output signal is full-range.
Woofer Hi-Cut: Cuts frequencies above 5kHz from the
20
woofer output.
Effects Send: This output allows signal from the
21
pre-amp to be fed to outboard effects devices from a
point after the EQ section.
Effects Return: This input allows the signal from
22
outboard effects devices to be inserted before the boost
section.
Tuner Out: Parallel output comes directly off of the
23
input stage. Unaffected by the mute button or any of the
pre-amp functions.
Power/Protect LED: The LED will be red for 5
24
seconds during power up, then turns blue when the amp
is ready. Should a fault occur, the amp will mute and the
LED will turn red until the fault is corrected.
Power On/Off Button: If you're not sure what this
25
does, you should probably not be operating
electronic equipment.
6
25
17 18 19 20
21
22
23 24