- ページ 5

コントローラー Agrowtek MX1iのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Agrowtek MX1i 12 ページ。 Intelligent reversing motor controller

Mounting the Relay

The MX1 intelligent relay is to be securely installed to a vertical wall surface using the four mounting holes

provided in the rear of the enclosure. Removing the front cover is required to mount and wire the relay.

Remove Cover

1. Loosen set screw on bottom of knob (1/8" flat screw driver) and remove the knob.

2. Loosen bottom two cover screws 1/4".

3. Remove top cover screws.

4. Tilt cover to clear knob shaft and lift off cover.

Mount Enclosure

1. Remove the front cover panel using caution not to damage the LED light pipes.

2. Locate the relay box and mark the mounting hole locations or use the dimensions below.

3. Pre-drill and install anchors if necessary. Keep dust and debris away from the circuit board.

Mounting hardware is not provided; drywall or deck screws of sufficient length are recommended.

DANGER! Risk of injury or death from electric shock; disconnect all power before wiring or service.

DO NOT drill holes into the enclosure or enlarge holes. Metal chips from drills can cause short circuits on the PCB.