Agrowtek MX1i Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Контроллер Agrowtek MX1i. Agrowtek MX1i 12 страниц. Intelligent reversing motor controller

Печатать страницу

Agrowtek MX1i Руководство по эксплуатации

Mounting the Relay

The MX1 intelligent relay is to be securely installed to a vertical wall surface using the four mounting holes

provided in the rear of the enclosure. Removing the front cover is required to mount and wire the relay.

Remove Cover

1. Loosen set screw on bottom of knob (1/8" flat screw driver) and remove the knob.

2. Loosen bottom two cover screws 1/4".

3. Remove top cover screws.

4. Tilt cover to clear knob shaft and lift off cover.

Mount Enclosure

1. Remove the front cover panel using caution not to damage the LED light pipes.

2. Locate the relay box and mark the mounting hole locations or use the dimensions below.

3. Pre-drill and install anchors if necessary. Keep dust and debris away from the circuit board.

Mounting hardware is not provided; drywall or deck screws of sufficient length are recommended.

DANGER! Risk of injury or death from electric shock; disconnect all power before wiring or service.

DO NOT drill holes into the enclosure or enlarge holes. Metal chips from drills can cause short circuits on the PCB.